Configuring The Ups; Changing The Language; Changing Display Functions - HPE G2 R5000 3U User Manual

• Extended overload
• Over temperature
• Output short
• Hardware failure

Configuring the UPS

Use the UPS front panel controls to configure the UPS.
IMPORTANT: The output voltage of the UPS must be set to the same nominal voltage as the facility input. Failure to do
so will cause the UPS to buck or boost constantly to maintain the output voltage.

Changing the language

Procedure
1. Press the Enter button to activate the menu options.
2. Press the down arrow button until the Settings menu appears on the LCD menu screen.
3. Press the Enter button.
4. Press the down arrow button until the Local settings menu appears on the LCD menu screen.
5. Press the Enter button.
6. Press the down arrow button until the Language menu appears on the LCD menu screen.
7. Press the Enter button.
8. Press and hold the Enter button to change the language on the UPS.

Changing display functions

The control panel automatically dims after a long period of inactivity. Press any button to restore the screen.
Press the Enter button to activate the menu options. Use the up and down arrow buttons to scroll through the menu structure.
Press the Enter button to enter a submenu or to select an option. Press the ESC button to cancel or return to the previous
menu.
Menu map for display functions
Main menu
Measurements
Control
Submenu Display information or menu function
— Load, Input/Bypass voltage, Output/Efficiency voltage, Battery percentage, Average
power usage, Cumulative power usage
Go to Bypass Transfers the UPS on Bypass mode
Start battery test Starts a manual battery test
Reset fault state Clears active fault
Restore factory set Returns all settings to original values
Table Continued
29
Operations