Bmc; Cable Routing Diagram - Supermicro SuperServer SYS-110P-FRN2T User Manual

3.10 BMC

The BMC can be reset using the button on the front control panel or on the chassis rear.
•
Reset—Press and hold the button. After six seconds, the LED blinks at 2Hz. The BMC
resets and the reset duration is ~250ms. Then the BMC starts to boot.
•
Restore factory default configuration—Hold the button for 12 seconds. The LED blinks at
4Hz while defaults are configured.
•
Firmware update—When the BMC firmware is updated, the UID LED blinks at 10Hz dur-
ing the update.

3.11 Cable Routing Diagram

Refer to the diagram below for a representation of how the main cables are routed throughout
the system. When disconnecting cables to add or replace components, refer to this diagram
when adding or replacing components so you can reroute them in the same manner. Proper
cable routing is important in maintaining proper airflow through the system.
SATA Cable
Fan Cable
CBL-OTHR-1214-24
Online Cable Matrix
Chapter 3: Maintenance and Component Installation
BMC Reset Options
Event LED
Reset Blinks at 2Hz
Restore
Blinks at 4Hz
Defaults
Update Blinks at 10Hz
CBL-0483L
Figure 3-16. Cable Routing Diagram
56