Table of Contents
Advertisement
Chapter 3: Maintenance and Component Installation
Removing the PHM from the CPU Socket
Be sure the system is shut down and all AC power cords are unplugged.
1. Use a t30-bit screwdriver to loosen the four PEEK nuts on the heatsink in the sequence
of A, B, C, and D.
B
D
PEEK Nut
C
A
2. Press the four rotating wires inward to unlatch the PHM as shown below.
Unlatched State
Top View
Rotating Wire
Side View
PEEK Nut
3. Gently lift the PHM upward to remove it from the CPU socket.
37
Advertisement
Table of Contents
Troubleshooting
