TechniSat MULTYRADIO 600 CD IR Manual page 78

19.2 Audio stream quality
The quality of the audio stream from the Internet radio station can be adapted to
suit the Internet speed (if available). The higher the quality, the higher the data
transfer rate.
> Press the MENU button and then select [System settings] > [Audio stream
quality].
> Select a quality level and press the OK button to save.
19.3 Internet settings
> Press the MENU button and then select [System settings] > [Internet
settings].
In this menu you will find some settings and information about Internet connection.
19.3.1 Network Wizard
> Select [Network wizard] to establish a WiFi connection.
The network wizard shows you all the WiFi stations within range. Use the
/ and OK buttons to select the WiFi network you recognise, select
[Skip WPS] and enter the password using the displayed keyboard. Then
select
a connection to the network is now established. The signal bars
status bar of the display indicate whether a connection exists.
To cancel the input, select
mistake, you can delete the last letter you entered by pressing
> If you want to establish a WPS connection instead of entering the password,
proceed as follows after selecting the WiFi network:
How you activate WPS on your router can be taken from its instruction
manual.
> Select [Press button] on the MULTYRADIO 600 CD IR after selecting the WiFi
network. Take note of the instructions on the display.
> Start WPS on your router by pressing the relevant button.
> If your router only supports the WPS PIN, select [PIN] on the MULTYRADIO
600 CD IR and take note of the PIN shown on the display. You then need to
enter the PIN in the router.
78
and press the OK button. If the password entered is correct,
and press the OK button. If you make a
in the
.