TechniSat MULTYRADIO 600 CD IR Manual page 67

12.2 Switching on DAB+ radio reception
> Press the MODE button repeatedly until [DAB+ Radio] appears in the display,
or press the DAB+ (13) button on the remote control.
Alternatively:
> Press the MENU button and then select [Main Menu > DAB+].
If DAB+ is being started for the first time, a complete station scan is
performed. The station list is then shown (see Section 12.4).
12.3 Scanning
The automatic scan scans all DAB+ band III channels and thereby finds all stations
being broadcast within the reception area.
After the scan is complete, the first station is played back in alphanumeric
order.
> Press the SCAN button to carry out a full scan. "Scan" appears on the display.
The scan starts and a progress bar appears on the display. The station list is
then shown
> When the scan is complete, press the  or  buttons when the station list is
displayed, and OK to select a station.
Alternatively:
> Press the MENU button and use the  or  buttons [Full Scan]. Confirm by
pressing OK.
If no stations are found, check the antenna and change the installation
location if necessary (Section 6.2).
12.3.1 Manual scan
Proceed as follows if you want to run a station scan manually:
> Select [Menu ] > [Set Manually] and press the OK button.
> Use the  or  buttons to select a station frequency and press the OK
button.
If stations are being broadcast on the selected frequency, this will be
indicated on the stability bar (see also Section 12.8). If these stations are not
currently included in your station list, they will now be stored there.
12.4 Calling up the station list
> You can use the station list to check and play back the stations found on the
device. To do this, press the  or  to call up the station list and highlight a
station.
> To select the highlighted station, press the OK key.
DE
EN
NL
67