Troubleshooting - Telex RadioCom BTR-200 II Operating Instructions Manual

Reread the sections of this manual to make sure
you have completed system set-up properly
PROBLEM
DISTORTION - System's audio quality
seems distorted at medium to high input lev-
els.
HISS - System seems to produce a "hiss"
which is undesirable.
LOW OUTPUT - System produces a low
output level.
FEEDBACK - Moving around area of use
produces "squeal" or "howl" in various loca-
tions using ext. speakers.
DROPOUTS - When moving around the area
of use there seems to be locations where the
signal "swooshes" or completely disappears.
INTERFERENCE - System picks up signals
other than wireless Intercoms.
NO AUDIO from BASE or BELTPACK
headsets.

TROUBLESHOOTING

If you are unable to solve the problem, con-
tact the dealer from whom you purchased the
system for assistance.
Reduce microphone gain by adjusting
microphone gain control.
Check the gain setting on all beltpacks and
the base. They may be too low.
Check the gain setting on both the beltpacks
and the base. They may be too low.
Reduce the gain settings on both the
beltpacks and the base. They may be too
high.
Make sure both antennas on the base are
connected and follow the location sugges-
tions. Change the location of the base unit
and antennas or avoid the bad areas with the
remote beltpacks.
Make sure Telex TR-200 beltpack is turned
on - this will usually eliminate the interfer-
ing signal. If not using a beltpack, make sure
the corresponding enable switch at the base
is disengaged.
If problems persist with the TR-200 beltpack
on, you will probably need to have your sys-
tem's frequency changed to another channel.
Check Transmitter switch on base, use
CONT or REMOTE position. Check
push-to-talk function - is the switch ON.
-34-
SOLUTION