Battery Removal - Telex RadioCom BTR-200 II Operating Instructions Manual

BATTERY REMOVAL

To remove the battery holder from the case to
change batteries, follow the instructions as be-
fore for removing the cover. Pull the pull-bale
strap on the holder, the holder should come
out. Some models will not have the pull bale.
If the pull bale is not present on the battery
holder, turn the unit over with the battery
holder facing downward. Give the case a slight
shake into the palm of your hand, the holder
should fall out.
REMOVE BELT CLIP
NOTE: For maximum uninterrupted service it
is suggested that new 1.5 volt alkaline AA bat-
teries (Mallory MN1500 or equivalent) be in-
stalled prior to each use. Avoid "shelf worn" or
"economical" batteries. Operation from heavy
duty nickel-cadmium batteries is also permissi-
ble, at the expense of operating time. (NEDA
10015 or equivalent). Typical life of fresh alka-
line batteries with the TR-200 is approximately
24 hours maximum, 8-10 hours is typical of
fully charged nickel-cadmium batteries.
NOTE: Nickel-cadmium batteries can be
charged right in the holder using the Telex
BC-4 Battery Charger. Refer to "Battery Infor-
mation" Section.
Figure 36
Battery Removal
-29-