Table of Contents
Advertisement
LOCATION
Locate the BTR-200 transceiver on a level sur-
face with the rear of the unit facing you. See
"Antenna Information" section for more infor-
mation on choosing a location.
INTERNAL INTERCOM SWITCHES
Intercom Dip Switch: Located in the inside of
the unit is a DIP Switch. This switch will have
to be set for the wired intercom unit you will
be using. The switch is factory set for interfac-
ing with Telex Audiocom wired intercom
units. See Table 1 if you will be using an RTS
or Clearcom wired intercom system.
Telex Audiocom
RTS
Clearcom
Dip Switch Positions For Wired Intercom Terminations
BTR-200 SET-UP
To change the switch positions you will need
to remove the cover on the BTR-200. Remove
three #6-32 x 3/8" screws on both sides of the
unit. Remove four #4-40 x 3/16" screws on the
top front and loosen three #4-40 x 3/16"
screws on the back of the unit. The cover will
slide off.
Reference Figure 17 for switch positions.
Change the switch positions as indicated in the
chart depending on the wired intercom system
you will be using. After setting this switch, set
the High/Low switch as shown in the next sec-
tion and then replace cover and secure with the
hardware previously removed.
SWITCH POSITION
1
2
3
ON
ON OFF ON OFF ON OFF OFF ON
OFF OFF ON OFF ON OFF ON
ON OFF ON
Table 1
FRONT
Figure 17
Dip Switch
-17-
4
5
6
ON OFF OFF OFF ON
7
8
9
ON OFF
ON
Hide quick links:
Advertisement
Table of Contents
