Troubleshooting - Telex RadioCom BTR-500/600C Operating Instructions Manual

Reread the sections of this manual to make sure you
have completed system set-up properly
PROBLEM
DISTORTION - System's audio quality seems
distorted at medium to high input levels.
HISS - System seems to produce a "hiss" which is
undesirable.
LOW OUTPUT - System produces a low output
level.
FEEDBACK - Moving around area of use
produces "squeal" or "howl" in various locations
using ext. speakers.
DROPOUTS - When moving around the area of
use there seems to be locations where the signal
"swooshes" or completely disappears.
INTERFERENCE - System picks up signals
other than wireless Intercoms.
NO AUDIO from BASE or BELTPACK headsets.

TROUBLESHOOTING

If you are unable to solve the problem, contact the
dealer from whom you purchased the system for as-
sistance.
-31-
SOLUTION
R e duc e m ic ro pho ne ga i n
microphone gain control.
Check the gain setting on all beltpacks and the
base. They may be too low.
Check the gain setting on both the beltpacks and
the base. They may be too low.
Reduce the gain settings on both the beltpacks and
the base. They may be too high.
Make sure both antennas on the base are
connected and follow the location suggestions.
Change the location of the base unit and antennas
or avoid the bad areas with the remote beltpacks.
Make sure the Telex beltpack is turned on - this
will usually eliminate the interfering signal. If not
using a beltpack, make sure the transmit mode
switch at the base is in the off position.
If problems persist with the beltpack on, you will
probably need to change frequency channels.
Make sure the base channel switch matches the
beltpack.
Check Transmitter switch on base, use CONT or
REMOTE position. Check push-to-talk function -
is the switch ON. Make sure beltpack batteries are
OK.
by a d j u st i n g