Equipment Set-Up; Unpacking; Antenna Information; Antenna Connections - Telex RadioCom BTR-200 II Operating Instructions Manual

Unpack your BTR-200 and TR-200 System. If
there are any damages or shortages, refer to the
"Warranty Service Information" section in this
manual.

ANTENNA CONNECTIONS

The BTR-200 is supplied with two (2) anten-
nas. One 5/8-wave antenna for Transmit and
one 5/8-wave for Receive.
Assemble the 5/8-wave antenna by screwing
the three sections into one another as shown in
Figure 8. All three sections of the BTR-200
5/8-wave antennas must be used. Leaving out a
section will result in reduced distance capabil-
ity.
DO
Figure 8
5/8-wave Antenna Assembly

EQUIPMENT SET-UP

UNPACKING

ANTENNA INFORMATION

DON'T
To insure that the frequency range of the anten-
nas match the receiver and transmitter of the
BTR-200, match the color code on the antenna
with the color code on the BTR-200.
Attach the receive 5/8-wave antenna to the an-
tenna input receptacle labeled "Receive An-
tenna" on the right side of the rear panel via
the supplied connectors. Attaching the angled
connector to the base station receptacle first,
then attaching the straight connector, as shown
in Figure 9, will prevent antenna sway.
Attaching 5/8-wave Antenna
-13-
Figure 9