Attach the transmit 5/8-wave antenna to the
antenna input receptacle labeled "Transmit An-
tenna" on the left side of the rear panel. The
antenna should be vertically aligned.
Figure 10
Transmit Antenna Receptacle
ANTENNA POLARIZATION
The Telex Wireless Intercom System is "Verti-
cally Polarized". This means both the transmit-
ting and receiving antennas should operate in
the vertical position.
Figure 11
Vertically Polarized Antennas
Headset
Ext Intercom
Aux Audio
Portable Stations
Carrier Status
1
2
3
4
Headset
Controls
Portable Station Connect
Power
Volume
DISTANCE BETWEEN ANTENNAS
The distance between the BTR-200 Receive
and Transmit antennas is not adjustable when
the antennas are connected directly on the back
of the unit.
The antennas can be remoted for better signal
path. A Telex coax assembly is required. See
"Accessory" section for order information.
NOTE: If your BTR-200 transceiver is to be
located in a shielded rack mount enclosure or
other poor RF location, you must remote the
5/8-wave antennas with coax assemblies.
BTR-200 II
Mic On
Push Twice to Latch
-14-