Battery Information; General; Bc-4 Battery Charger - Telex RadioCom BTR-200 II Operating Instructions Manual

BATTERY INFORMATION

Improper battery selection, use, installation
and care are the cause of numerous wireless
system failures.
Alkaline Batteries: Alkaline batteries such as
Mallory's DURACELL or Eveready's ENER-
GIZER provide the most reliable operation in
wireless transceivers. The use of low cost car-
bon-zinc batteries is NOT recommended.
Remove the battery holder from the TR-200.
NOTE: The BC-4 is not supplied with the
TR-200. See "Accessory" Section for ordering
information.
CAUTION
DO NOT ATTEMPT TO CHARGE
ANY ALKALINE BATTERIES WITH
THIS CHARGER. THIS CHARGER IS
TO BE USED WITH NICKEL CAD-
MIUM BATTERIES USED IN THE
TR200 BATTERY HOLDER ONLY.
Snap the terminal connector onto the battery
holder and plug the charger into a 110 Volt out-
let.
ENERGIZER® is a registered trademark of Union Carbide Corpora-
tion.
DURACELL® is a registered trademark of Duracell Inc.

GENERAL

Nickel-Cadmium Batteries: These batteries
can save you money in the long run, as they
can be recharged, but they can also cause dis-
appointing wireless performance. Typical bat-
tery life is one fourth or less of the alkaline
battery. If you want to use rechargeable
nickel-cadmium batteries you must select a
heavy duty nickel-cadmium (NEDA 10015 or
equivalent)

BC-4 BATTERY CHARGER

Full charge of the battery pack is obtained after
14 to 16 hours. A full charge will last 8 to 10
hours.
Extensive over-charging may damage or de-
stroy the batteries. Please ensure the charging
time does not exceed 16 hours.
-35-
Figure 41
BC-4 Battery Charger