Tr-200 Set-Up; Headset Connection; Dynamic/Electret Mic Switch - Telex RadioCom BTR-200 II Operating Instructions Manual

HEADSET CONNECTION

Insert the headset/microphone into the connec-
tor on the bottom of the unit. See the headset
connection diagram (Figure 5) if unit other
than Telex is used.
TO HEADSET
Figure 27
Connecting Headset

TR-200 SET-UP

DYNAMIC/ELECTRET SWITCH
If the headset you are using has an Electret mi-
crophone, the dynamic/electret switch must be
in the "E" position (Electret). This switch is
accessible by removing the belt clip and re-
moving the battery holder. A +5 volt bias is
available at the microphone plug for electret
use.
If you are using a headset with a dynamic mi-
crophone, place the dynamic/electret switch in
the "D" position (Dynamic).
NOTE: FOR PROPER OPERATION YOU
MUST MATCH THE TYPE OF MICRO-
PHONE YOU ARE USING WITH THE DY-
NAMIC/ELECTRET SWITCH LOCATED
INSIDE THE BATTERY COMPARTMENT.
-24-
FCC ID: B5DTR200
MADE IN U.S.A.
S / N : MIC
P / N : 7 0 6 8 1- E D
ELECTRET DYNAMIC
Figure 28
Dynamic/Electret Switch