Beltpack Set-Up; Battery Installation - Telex RadioCom BTR-800 Operating Instructions Manual

Beltpack Set-up

Battery Installation

Ensure that the On/Off volume control knob is turned off.
Press down and hold down the battery release latch, slide the
battery pack about 1/8 inch back, toward the latch, until it
stops. Then lift battery pack out. Replace batteries as follows:
1. Open the battery pack by inserting
finger nail and lifting.
2. Pull battery strap to remove low
or dead batteries.
3. Load new batteries following the
4. Start loading at the end of the case where
the strap is attached to the case.
5. Be sure strap goes under batteries.
6. Tuck end of strap under door
when placing the battery cover
back on the case.
Figure 26
Battery Installation
polarity as shown in battery case
Do not place an alkaline TR battery
pack in any battery charger. Severe
charger and battery pack damage
may result.
4-12
WARNING