Tr-700 Beltpack; Con Trols And Con Nec Tions - Top Panel - Telex RadioCom BTR-700 Operating Instructions Manual

Con trols and Con nec tions - Top Panel

1. On/Off & Vol ume Con trol – Turns the beltpack power
on and con trols head set vol ume.
2. Bat/Overmod Light – Light will flash once when unit is
turned on if the bat tery is good. If the light stays on, bat -
tery is low. If the light does not flash, bat tery is dead. A
nor mal microphone gain set ting will cause the LED to
flash at the be gin ning of most words at nor mal speech
levels. If the gain is too large, the LED will be red dur ing
the com plete word at nor mal speech lev els.
1
Telex
R
OFF
VOL
Fig ure 4
TR-700 Top Panel
3-1
2 3
BAT/OM TALK
4
TALK
3. Talk Light – LED is on when the talk but ton is ac tive.
4. Talk but ton – Press to en able the au dio path from the lo -
cal head set microphone. The "TALK" LED, #3, will turn
red when en abled. A quick press and re lease latches the
talk function, un less latch ing has been dis abled in soft -
ware. Holding the but ton for over ½ a sec ond will cause
the au dio path to be en abled only for as long as the but ton
is held. If the talk function is latched on, press ing the talk
but ton again will turn it off.
S
ection
3

TR-700 Beltpack