Jeep GLADIATOR 2023 Owner's Manual page 71

Phone & Bluetooth® Pairing
A feature of the Jeep® wireless speaker is the ability for
the Jeep® wireless speaker to connect to devices using
Bluetooth®. Follow these simple steps to connect a
Bluetooth®-enabled device to the Jeep® wireless
speaker:
1. Press and hold the power button for 2-3 seconds to
turn the Jeep® wireless speaker on.
2. Turn "on" Bluetooth® for the device you desire to be
connected to the Jeep® wireless speaker. For
instructions on how to turn on and off Bluetooth®
settings for the desired device, refer to the device's
user manual.
3. When powered on, the Jeep® wireless speaker will
automatically enter pairing mode. To pair a second
device, press and hold the Bluetooth® button for
2-3 seconds, until an audio cue is heard. Then go
to the devices' Bluetooth® settings and select
"Jeep® Speaker" from the list.
The Jeep® wireless speaker will remember the last
eight devices it has paired with.
NOTE:
If the Jeep® wireless speaker is left on with an inactive
Bluetooth® connection for 30 minutes, it will automati-
cally turn off. The Jeep® wireless speaker can be turned
on again by pressing and holding the power button for
2-3 seconds.
Resetting Your Jeep® Wireless Speaker
To reset the Jeep® wireless speaker to its original factory
setting, press and hold the reset button under the back
cover for 8-10 seconds.
Speakerphone
The speakerphone feature can be used by pressing the
"Voice Control" button on the Jeep® wireless speaker.
This feature can be used to answer and end calls over the
speakerphone.
Volume And Playback Control
Volume can be increased or decreased by briefly pressing
the + button or - button. When the maximum volume is
reached, an audio cue will sound.
To skip to the next track, press and hold the + button.
To go to the previous track, press the - button.
Qualcomm TrueWireless™ Stereo
A feature of the Jeep® wireless speaker is being able to
pair two Jeep® wireless speakers together for Qualcomm
TrueWireless™ Stereo. This feature allows for two Jeep®
wireless speakers to play left and right stereo sound.
Below are the steps needed for Qualcomm TrueWireless™
Stereo:
1. Push and hold the power button on both
Jeep® wireless speakers until both speakers
turn on.
GETTING TO KNOW YOUR VEHICLE
2. Place both speakers into Qualcomm TrueWireless™
Stereo pairing mode. This can be achieved by
pressing and holding the Battery Status button on
both speakers until an audio notification is heard
from both speakers.
3. Connect one of the Jeep® wireless speakers to the
Bluetooth® source. Refer to previous section "Phone
& Bluetooth® Pairing" for additional information.
4. Once the Jeep® wireless speaker is connected to the
Bluetooth® device, audio will be played from both
speakers.
NOTE:
While in Qualcomm TrueWireless™ Stereo mode, the
volume will not have independent speaker control.
Pushing the Up or Down Volume button on either Jeep®
wireless speaker will affect the audio output on both, as
well as volume adjustments on the Bluetooth® device.
Waterproof Features
The Jeep® wireless speaker is IP67 waterproof certified
with design in mind to withstand rainfall, waterjets,
splashing and being submerged in up to 3 ft (1 m) of
water for up to 30 minutes.
WARNING!
Any modifications or alterations to this vehicle could
seriously affect its roadworthiness and safety and may
lead to a collision resulting in serious injury or death.
69
2