Table of Contents
Advertisement
4.2. Torque Adjustment
The required torque for the driver can be adjusted externally as follows:
1.
Disconnect Screwdriver from air supply.
2.
Insert torque setting screwdriver through one of the three openings of the
motor housing into the half-round bore of the lock ring. (If necessary, turn
clutch using bit)
3.
By turning the torque-setting screwdriver clockwise, the torque is re-
duced and by turning it counter-clockwise, the torque is increased.
half-round bore
for torque setting-
screwdriver
Picture: Torque Adjustment
4.3. Bit Exchange
Attention:
Before exchange of bits, clutch bearing has to be in place and
driver needs to be disconnected from air supply.
To change bits, refer to picture Change of bits:
• Unscrew spring sleeve 364672 A (Accessories - Optional equipment) (left-
hand thread) – only necessary if a finder is mounted.
• Pull the lock sleeve 351890 forward, the bit can now be removed or
inserted.
Picture: Change of bits
14
Advertisement
Table of Contents
