Table of Contents
Advertisement
adjustment
nut
Picture: Exchange of clutch spring
Make sure to screw adjustment (adjusting) nut onto clutch bearing
until one line of the thread is visible.
4.2. Torque Adjustment
For an external torque adjustment use the following steps:
1.
Disconnect the screwdriver from the air supply.
2.
Unscrew the cylinder head screw 800486 from the guide bolt. Turn and
pull out the reduction gear carefully, until a slot on its housing and a slot
on the motor housing of the screwdriver becomes visible.
3.
Push the supplied hand screwdriver 326240 through the slot on the mo-
tor housing into the half-round bore of the lock ring (if necessary, turn bit
by hand).
4.
By turning the hand screwdriver clockwise (-), the torque is reduced and
by turning it counter-clockwise (+), the torque is increased.
5.
Re-assemble the reduction gear onto the screwdriver and tighten it by
means of the cylinder head screw onto the guide bolt.
half-round
bore for hand
screwdriver
Picture: Torque Adjustment
clutch spring
half-round
bore
13
claw of the
intermediate ring
Advertisement
Table of Contents
