Table of Contents
Advertisement
4.4. Connection-Possibilities of the Function Control
• Use as air pressure outlet during screw-assembly:
to control driver start and stop, as well as shut-off control of clutch;
-
as cycle counter of the complete process;
-
each in connection with a PE- Switch or similar.
• Use as air pressure inlet:
if 6,3 bar (90 PSI) air pressure is given to the function control port,
-
the driver starts rotating at about 15 % of its speed. This will
simplify the engagement of bit/socket to fastener (for example
when driving hex screws, nuts, etc.)
Function Description / Driver Start
Picture: Connections of remote valve
The driver is activated immediately when air is connected. The flow rake of
the remote valves must not be below 0,6 m³/min.
15
Advertisement
Table of Contents
