Table of Contents
Advertisement
5 Assembly - Disassembly
Disassembly: (see Spare Parts Drawing)
Prior to disassembly, disconnect equipment from air
supply! Only experienced maintenance personnel may
assemble or disassemble this equipment.
After repair or maintenance, verify that equipment runs to specification!
Principally, use only DEPRAG original spare parts. Otherwise, a reduction
in equipment power-output and an increased maintenance-requirement
occurs. If NON-DEPRAG parts are installed, DEPRAG is justified to void
any existing warranty and liability obligations.
Attention:
Motor- and gearing parts may be damaged if dropped!
For disassembly proceed in the sequence described below:
1.
Disconnect driver from air supply.
2.
Unscrew clutch bearing together with spring sleeve.
3.
Remove complete clutch.
4.
Disassemble guide bolt by removing hex. nut 826715.
5.
Clamp the driver into a vice, utilizing the flats of the flange and unscrew
the sleeve 384494 (right-hand thread).
6.
Hold motor housing using a 24-mm wrench and use the key 462122 to
remove the valve housing 384469 (right-hand thread).
7.
Remove valve pin.
8.
Clamp mounting tube 460566 into vice and use the provided arbor to
push the motor- and gear parts out of the motor housing in direction of
the air inlet. Any other suitable arbor may be used to carefully push the
motor- and gearing parts out of the motor housing (without mounting
tube)
16
Advertisement
Table of Contents
