Table of Contents
Advertisement
adjustment nut
half-round bore
Attention:
The claw of the intermediate ring must engage with the claw of
the spindle!
Check this and ensure that engagement lift on the spindle is
available.
8.
An external torque adjustment of the clutch is again possible (see section
Torque Adjustment).
Make sure to screw adjustment (adjusting) nut onto clutch bearing
until one line of the thread is visible.
4.2 Torque Adjustment
For an external torque adjustment use the following steps:
1.
Disconnect driver from air supply.
2.
Insert the supplied hand screwdriver through one of the slots in the motor
housing into the half-round bore in the lock ring (if necessary turn bit by
hand)
3.
By turning the hand screwdriver 326240 clockwise, the torque is reduced
and if turned counter-clockwise, the torque is increased.
half-round
bore for
hand screwdriver
Picture: Torque Adjustment
clutch spring
13
Advertisement
Table of Contents
