Table of Contents
Advertisement
Items such as foam rubber (latex foam), shower caps, rubber backed articles, clothes
z
or pillows fitted with foam rubber pads, waterproof textiles, shoes containing rubber or
plastic items should not be placed in the appliance. These materials can spontaneously
combust when heated.
Do not dry unwashed items in the appliance.
z
When using
REFRESH BY STEAM
z
flammable substances on them.
Installation
The appliance must not be supplied through an external switching device, such as a
z
timer, or connected to a circuit that is regularly switched on and off by a utility.
We do not recommend the use of extension cords or portable electrical outlet devices
z
for safety reasons.
Install the appliance on a solid and level floor surface.
z
The appliance must be installed in a well-ventilated, dust-free environment.
z
The appliance must not be installed on any textured floor coverings (eg carpet, rugs).
z
Ensure that openings at the base of the appliance are not obstructed.
The appliance must not be installed behind a lockable door, a sliding door or a door
z
with the hinge on the opposite side to that of the tumble dryer, in such a way that a full
opening of the tumble dryer door is restricted.
If installing behind a cabinetry door, it must be hinged on the same side as the dryer
z
and there must be a minimum clearance of 40mm from the front of the dryer door to
the internal face of the cabinetry door for the product to operate safely. The enclosed
space must be provided with sufficient ventilation to meet local building code
requirements or the door must be open while the product is operating.
This appliance can be installed on a compatible Fisher & Paykel plinth. To ensure
z
stability, the plinth must be fitted correctly with the appliance. For installation
instructions and compatible plinth models, refer to fisherpaykel.com.
Do not install or operate this appliance on any other plinth or structure.
z
For more information refer to the installation guide. To access, go to fisherpaykel.com/
z
specify and search by appliance type, product name or model.
Water supply requirements
Inlet water pressure: Max. 1MPa (145psi), Min. 30kPa (4.5psi)
z
Inlet water flow rate: Min. 6 litres/minute
z
The cold water temperature should not exceed 35°C. Temperatures above these may
z
cause the appliance to fault or cause damage to it.
A pressure-reducing valve must be installed if pressure is higher than 1Mpa.
z
New hose sets provided should be used to connect the appliance to the water mains.
z
Old hose sets should not be re-used.
We recommend the inlet hose(s) are changed every 5 years. WARNING: Failure to do so
z
may result in a flood and damage to property.
Disposal
When disposing of this appliance, it is recommended that the door is removed to
z
avoid children getting trapped inside, and that the electrical cable is cut off close to
the dryer.
SAFETY AND WARNINGS
cycles on unwashed clothing ensure there are no
7
Advertisement
Table of Contents
