Table of Contents
Advertisement
PROBLEM
Vibration
Cycle taking
too long
30
TROUBLESHOOTING
POSSIBLE CAUSES
Dryer is not installed on
a stable surface.
Dryer is not level.
Dryer is overloaded.
Cycle selected not
appropriate for the load.
Dryness level selected not
appropriate for the load.
Dryer is overloaded.
Lint filter, condenser filter,
filter foam or evaporator
grid is blocked.
Water tank is full.
Environmental conditions
may be affecting operation.
Load overly wet at the
start of cycle.
Load was damp dry at
the start of cycle.
Dryer is not draining
properly.
Items are tangled.
WHAT TO DO
Ensure the dryer is installed on
a flat, stable surface. Refer to
installation guide.
Ensure the dryer is level. Refer to
installation guide.
Remove some items from the dryer.
Select an appropriate cycle for the
load. Refer to 'Cycles'.
Select a lower dryness level. Refer to
'Cycle settings'.
Remove some items from the dryer.
Check and clean the lint filter,
condenser filter, filter foam and
evaporator grid.
If the problem persists the filter foam
may need to be replaced. Refer to
'Condenser filter.'
Refer to 'Water tank'.
In particularly hot or cold conditions
cycles may take longer and
be less efficient.
Ensure the dryer is installed in a
well-ventilated, dust-free environment.
Do not operate this dryer behind
closed doors (ie inside a cupboard).
Remove more water from the
load before placing it in the dryer,
eg select a faster spin speed on your
washer, if appropriate for your load.
If the load had been partially air dried,
eg has been washed and placed on
the line, use a
TIME DRY
monitor the dryness of your clothes.
Check the drain hose (if connected)
for blockages or damage. If
the problem persists contact
Customer Care.
Try separating items and
drying similar items together.
Refer to 'Loading suggestions'.
cycle and
Advertisement
Table of Contents
