Table of Contents
Advertisement
3.3
Commissioning
3.3.1
Setting the infrared sensor
Programming block
Programming the settings
Flush plate Visign for Public 6
Programming the control can be carried out for 30 minutes after the
supply voltage is applied. The control returns to normal operation after
30 minutes – programming is now blocked. If the settings have to be
changed after this time, the control must be disconnected from the
power supply for at least 10 seconds.
Observe the following features during programming:
Only one value can be set per programming step.
n
The settings are retained, even if there is an interrup‐
n
tion in the power supply.
The programming procedure can be interrupted
n
without changing the settings by covering the infrared
sensor until the flashing signal has stopped for more
than 2 seconds.
Requirements:
The control programming block is not active.
n
▶
Cover infrared eye (e. g. with a finger or a hand).
▷
The diode blinks twice after 10 seconds. Settings mode has
been activated. The first blinking signal is given after a further
5 seconds. The first setting is active.
Handling
34
Advertisement
Table of Contents
