Table of Contents
Advertisement
Connecting the control
Flush plate Visign for Public 6
Observation of the prescribed connection sequence is
required. The power supply must always be connected
last, to ensure that all of the connected components func‐
tion.
INFO!
Mounting is much easier if the plug is inserted into the
control outside of the cistern.
▶
Connect the red plug of the Bowden cable unit motor to the red
connection of the control.
▶
Connect the blue connection cable from the sensor to the blue con‐
nection of the control.
Also observe section
sors' on page 33.
▶
Connect the black cable of the power supply to the outer right con‐
nection of the control.
INFO!
Settings for the control can also already be made at
this point. The programming set is easier to connect if the
control is not yet installed in the cistern.
'Commissioning' on page 34
Ä Chapter 3.2.5 'Connecting external sen‐
Ä Chapter 3.3
Handling
27
Advertisement
Table of Contents
