3.2.5
Connecting external sensors
3.3
Commissioning
3.3.1
Setting the infrared sensor
Programming block
Visign for More 100 equipment set
NOTICE!
Damage to property due to excess voltage
If you apply voltage to the connection cable for the
external button, you will damage the control.
Do not apply any external voltage!
n
Requirements:
On site button with closing function or potential-free contact avail‐
n
able
Extension cable model 2241.95 available
n
▶
Remove the jack from the extension cable model 2241.95.
▶
Connect the contact to actuate the flush cycle to the extension
cable.
▶
Connect the extension cable to the control.
▶
Continue with the mounting of the flush plate. See
„Mounting the flush plate" on page 16.
Programming the control can be carried out for 30 minutes after the
supply voltage is applied. The control returns to normal operation after
30 minutes – programming is now blocked. If the settings have to be
changed after this time, the control must be disconnected from the
power supply for at least 10 seconds.
Handling
Ä Chapter 3.2.4
18