Table of Contents
Advertisement
4.3.53 Operator Call
Allows you to call an operator within the system.
PT and SLT
Lift the handset or press
SP-PHONE/MONITOR.
Conditions
• If no operator is assigned, this feature is not available and you will hear a reorder tone after
dialing the feature number.
• Operator FDN
The treatment of incoming calls to Operator is decided according to "Operator FDN" setting
of the tenant <Section 2.2 Tenant, "Operator FDN" in the Programming Guide>.
— If the FDN for Operator Group is set as the destination of Extension Group or Incoming
Group, calls by the feature number for "Operator Call" will arrive at the destination.
— If it is set to "Blank," calls will arrive at the destination of Extension Group.
• If the FDN except for Operator Group is set, or if the FDN for Operator Group is set as the
destination of Extension Group in other tenants, calls will arrive at the destination of
Extension Group.
• An operator-seeking incoming call to the PDN of owner extension does not appear on the
SDN button.
• A call to a single operator hunts for an idle extension as follows;
<For Extension Group members>
— in numerical order of the extension port physical numbers, starting at the extension
following the last one called
<For Incoming Group members>
— in the order assigned in the Incoming Group
It is programmable whether to start at the extension following the last one called or to
always start at the first assigned extension by System Programming <Section
3.5 Incoming Group, "Search Mode" in the Programming Guide>.
Programming Guide References
• 1.4 Extension Port Assignment
– Group No.
• 2.2 Tenant
– Operator FDN
User Manual
0
Dial 0.
You may dial the FDN (3-4 digits)
for the Operator Group instead.
Station Features and Operation (PT/SLT)
325
Advertisement
Table of Contents
