Table of Contents
Advertisement
Station Features and Operation (PT/SLT)
4.3.80 UCD Login Monitor
Allows an extension user (PT only) to see at a glance which UCD Group Members are logged
in and which ones are logged out.
Write down the DNs of the UCD Group Members that you want to monitor. Write them on the
"TEL CARD" of your PT.
Using Station Programming <Section "2.2.3 Flexible Button Assignment" in this manual>,
User Programming <Section "3.2.5 [005] Flexible CO Button Assignment" in this manual>
or System Programming <Section "4.3 Extension Line" in the Programming Guide>, assign
each DN to a DSS button on your PT.
Extension Group
Enable "LOGIN Monitor" <Section "3.3 Extension Group" in the Programming Guide> for
your UCD group.
Incoming Group
Specify the "Supervisor Extension" <Section "3.5 Incoming Group" in the Programming
Guide> for your UCD group.
When a UCD Group Member is logged out, the corresponding DSS button on your PT will
flash red.
Programming Guide References
• 3.3 Extension Group
– Group Type
– [UCD Setting] LOGIN Monitor
• 3.5 Incoming Group
– Group Type
– [UCD Setting] Supervisor Extension
• 4.3 Extension Line
– CO Key
• 4.4 DSS Console
– DSS Key
Features Guide References
1.5 Attended Features
• Uniform Call Distribution (UCD)
User Manual References
• 2.2.3 Flexible Button Assignment
• 3.2.5 [005] Flexible CO Button Assignment
392
User Manual
Advertisement
Table of Contents
