Installing Dimms - Supermicro X6DAi-G User Manual

Supermicro x6dai-g motherboards: user guide
Table of Contents

Advertisement

2-3

Installing DIMMs

Note: Check the Supermicro web site for recommended memory modules.
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the
memory is interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-2)
1. Insert the desired number of DIMMs into the memory slots, starting with
DIMM #1A. The memory scheme is interleaved so you must install two
modules of the same memory type and of the same memory speed at a
time, beginning with DIMM #1A, then DIMM #1B, and so on.
2. Insert each DIMM module vertically into its slot.
notch along the bottom of the module to prevent inserting the DIMM
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Memory Support
The X6DAT-G/X6DAi-G supports up to 16 GB of ECC registered DDR333 or
up to 32 GB of ECC registered DDR266 SDRAM memory. Both motherboards
were designed to support 4 GB modules in each slot, but have only been
verified for up to 2 GB modules. (*When Registered ECC DDR333-PC2700
memory modules are used, we recommend that up to four double-banked
memory modules be installed on the motherboard.)
Figure 2-2.
To Install: Insert module vertically and press down
until it snaps into place. Pay attention to the
alignment notch at the bottom.
CAUTION
Installing and Removing DIMMs
2-5
Chapter 2: Installation
Pay attention to the

Advertisement

Table of Contents
loading

This manual is also suitable for:

X6dat-g

Table of Contents