Table of Contents
Advertisement
SUPER P6SWA/P6SWD
2-4
Installing DIMMs
Exercise extreme care when installing or removing DIMM modules
DIMM Installation (See Figure 2-2)
1. Insert DIMMs in Bank 0 through Bank 1 as required for the desired system
memory.
2. Insert each DIMM module vertically into its socket. Pay attention to the
two notches along the bottom of the module to prevent inserting the
DIMM incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
socket.
4. If installing only a single DIMM, you may use either Bank 0 or 1.
PC100
To Install:
Notches
Insert
vertically,
press down
until it snaps
into place.
Pay attention
to the two
notches.
Top View of DIMM Socket
Manual
CAUTION
to prevent any possible damage.
Figure 2-2. DIMM Installation
Side View of DIMM Installation into Socket
2-4
DIMM
Note: Notches
should align
with the
receptive points
on the socket
D I M M S o c k e t
To Remove:
Use your thumbs to
gently push near
the edge of both
ends of the module.
This should release
it from the slot.
PC100
Notches
Advertisement
Table of Contents
