Table of Contents
Advertisement
Appendix C: Software Installation: Adaptec's SATA HostRAID Utility
Using the Disk Utilities
The Disk Utilities enable you to format or verify the media of your Serial ATA
hard disks.
To access the disk utilities:
1. Turn on your computer and press Ctrl+A when prompted to access the
ARC utility.
2. From the ARC menu, select Disk Utilities.
3. Select the desired disk and press Enter. You are offered the following
options:
* Format Disk—Simulates a low-level format of the hard drive by writing
zeros to the entire disk. Serial ATA drives are low-level formatted at the
factory and do not need to be low-level formatted again.
!(Caution: Formatting destroys all data on the drive. Be sure to back up your
data before performing this operation.
* Verify Disk Media—Scans the media of a disk drive for defects.
C-19
Advertisement
Table of Contents
