Control Panel - Supermicro 8042-6 User Manual

S S
UPER ERVER 8042-8/8042-6 Manual
Extra Rack Unit
Retention Screw (2)
Top Cover
Thumbscrew (2)
Slim CD-ROM Drive
S
R
UPERMICR
Rack Unit Retention
Screw (2)
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the serverboard to provide you with system
status and alarm indications. A ribbon cable has bundled these wires
together to simplify the connection. Connect the cable from JF1 on the
serverboard (making sure the red wire plugs into pin 1) to JP9 on the
Control Panel PCB (printed circuit board). Pull all excess cabling out of
the airflow path. The LEDs inform you of system status. See Chapter 3:
System Interface for details on the LEDs and the control panel buttons.
Figure 6-2 shows the connections, jumpers and indicators located on the
control panel PCB. Details on JF1 can be found in the Chapter 5:
Advanced Serverboard Installation.
Floppy Drive
Power Supplies
Figure 6-1. Chassis Front View
Control Panel
System LEDs
SCSI Drives
6-2
Main Power
Alarm Reset
System Reset
ALARM RESET