Checking The Serverboard Setup - Supermicro 8042-6 User Manual

2-5

Checking the Serverboard Setup

After you install the 8042-8/8042-6 in the rack, you will need to open the
unit to make sure the serverboard is properly installed and all the connec-
tions have been made.
1. Accessing the inside of the 8042-8/8042-6 (see Figure 2-5):
First, release the retention screws that secure the unit to the rack.
Next, release the two thumbscrews that secure the top cover to the
chassis. Grasp the two handles on either side and pull the unit
straight out until it locks (you will hear a "click"). There are two
square recesses in the top cover to help you push the cover away
from you until it stops. You can then lift the top cover from the
chassis. You now have full access to the inside of the server.
2. Check the CPUs (processors):
The processors are enclosed in an air shroud. You should one to four
processors fully inserted into the serverboard.
have its own heatsink attached. See Chapter 5 for instructions on
processor installation.
3. Check the MEC:
The Memory Expansion Card (MEC) should be already installed. Make
sure the MEC is fully seated in its slot and that its retention plate is
screwed firmly to the chassis. For details on populating the MEC,
refer to Chapter 5.
4. Installing add-on cards:
Install any add-on cards that you want added to the system. See
Chapter 5 for details on installing PCI add-on cards.
5. Check all cable connections and airflow:
Make sure all power and data cables are properly and firmly connected
and not blocking the airflow. See Chapter 5 for details on cable
connections.
Chapter 2: Server Installation
2-7
Each processor should