Supermicro 8042-6 User Manual page 37

Note: You need a pair of identical 603 clips (shown on left above) for each
Gallatin 1.9 - 2.8 GHz CPU. You need a pair of identical 603E clips (shown
on right above) for each Foster 1.4 - 1.6GHz CPU.
1. Lift the lever on the CPU socket:
lift the lever completely or you will
damage the CPU socket when
power is applied.
first.)
2. Install the CPU in the socket.
Make sure that pin 1 of the CPU is
seated on pin 1 of the socket (both
corners are marked with a tri-
angle). Install a CPU into CPU
socket #1 first (you may install ei-
ther two or four CPUs).
3. Press the lever down until you
hear it *click* into the locked posi-
tion.
Chapter 5: Advanced Serverboard Setup
MP Processors
(Install CPU1
5-3
Socket lever
Pin 1
Socket lever in
locked position