Installing The System Into A Rack - Supero SuperServer 6025B-8 User Manual

S S
UPER ERVER 6025B-T/6025B-8 User's Manual
2-4

Installing the System into a Rack

This section provides information on installing the SuperServer 6025B-T/6025B-8
into a rack unit. If the 6025B-T/6025B-8 has already been mounted into a rack, you
can skip ahead to Sections 2-5 and 2-6. There are a variety of rack units on the
market, which may mean the assembly procedure will differ slightly. The following
is a guideline for installing the system into a rack with the rack rails provided. You
should also refer to the installation instructions that came with the rack unit you
are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the 6025B-T/6025B-8. Each
of these assemblies consist of two sections: an inner fi xed chassis rail that secures
directly to the 6025B-T/6025B-8 (A) and an outer fi xed rack rail that secures directly
to the rack itself (B). All screws and hardware mentioned in the installation steps
should be included in the hardware kit.
To remove the fi xed chassis rail (A), pull it out as far as possible - you should hear
a "click" sound as a locking tab emerges from inside the rail assembly and locks
the inner rail. Then depress the locking tab to pull the inner rail completely out.
Do this for both the left and right side rack rail assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
Locking Tab
A
2-4
B