Table of Contents
Advertisement
S
S
UPER
ERVER 6025B-T/6025B-8 User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 6025B-T/6025B-8 lies the X7DBE/X7DB8, a dual
processor serverboard based on the Intel 5000P chipset and designed to provide
maximum performance. Below are the main features of the X7DBE/X7DB8. (See
Figure 1-1 for a block diagram of the Intel 5000P chipset).
Processors
The X7DBE/X7DB8 supports single or dual Intel dual-core Xeon processors 5000
series at a FSB speed of 1333 MHz. Please refer to the serverboard descrip-
tion pages on our web site for a complete listing of supported processors (www.
supermicro.com).
Memory
The X7DBE/X7DB8 has eight 240-pin DIMM slots that can support up to 32 GB of
ECC FBD (Fully Buffered DIMM) DDR2-667 or DDR2-533 SDRAM. The memory
is an interleaved confi guration, which requires modules of the same size and speed
to be installed in pairs.
Serial ATA
A SATA controller is integrated into the South Bridge of the 5000P chipset to
provide a six-port Serial ATA subsystem, which is RAID 0, 1, 10 and 5 supported.
The Serial ATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
Onboard SCSI (6025B-8 only)
An onboard Adaptec AIC-7902 dual-channel SCSI controller in integrated into the
X7DB8, which supports 80-pin SCA Ultra320 SCSI hard drives. (Standard 1" drives
are supported. SCA = Single Connection Attachment.) The SCSI drives are con-
nected to an SCA backplane that provides power, bus termination and confi guration
settings. The SCSI drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the SCSI drives.
1-2
Advertisement
Table of Contents
