Table of Contents
Advertisement
Chapter 6: Advanced Chassis Setup
6-5
Power Supply
The SuperServer 6025B-T/6025B-8 has a single 550 watt power supply, which is
auto-switching capable. This enables it to automatically sense and operate with a
100v - 240v input voltage.
Power Supply Failure
If the power supply module fails, the system will shut down and you will need to
replace the module. Replacements can be ordered directly from Supermicro (see
contact information in the Preface). As the power supply module in the 6025B-
T/6025B-8 is not cold-swappable, you will need to remove the chassis cover and
disconnect all power cables from the power supply unit before removing and replac-
ing the power supply.
Removing/Replacing the Power Supply
1. Removing the power supply
First unplug the power cord from the power supply module. Remove the cover
from the chassis and disconnect all power cables from the motherboard and any
components. Then remove the screws that secure the power module to the chas-
sis. Finally, pull the module straight out by the handle.
2. Installing a new power supply
Replace the failed power supply with another SP552-2C power supply module (p/n
PWS-0047). Reconnect all power cables from the power supply to the motherboard
and components. Replace the chassis cover and reconnect the AC power cord.
Finish by depressing the power button on the chassis front control panel to restart
the system.
6-9
Advertisement
Table of Contents
