CAUTION Providing Stability
Make sure that the supporting feet
after positioning it at its intended location.
Note
Lift the device only by using the lifting points.
CAUTION Heavy loads! Lift with care!
To avoid injury through physical strain, such as strain traumata and slipped discs, do not attempt to
lift the incubator alone!
To avoid injury through dropped loads, be sure to wear Personal Protection Equipment, such as
safety shoes, when lifting the incubator. To avoid crushing your fingers or hands (particularly in a
closing door) or damaging the incubator, do not use any other lift points than those indicated in
the illustration above.
CAUTION
Tilting of units on a support stand with castors.
Moving units must be done very carefully. Ungentle slow down or accelerating of the unit or units
may result in tilting from the support stand with castors. Don't move with front door open. The
support stand with castors should only be used for the near vincinity of the installation side, inside
the laboratory, not for transportation purposes.
Thermo Scientific
(Figure
2-9) are screwed out and adjusted with a pipe wrench
2
Installation of the Device
S
i160 LK / i250 LK
TERI-CYCLE
Stacking
2-11