Adding Pci Cards - Supermicro SUPERSERVER 6021i User Manual

Figure 5-5a.
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notches.
Use your thumbs to gently push each release tab outward to free the
DIMM from the slot.
Figure 5-5b.
Release Tab
To Remove:
Use your thumbs to gently push each release tab outward.
This should release the DIMM from the slot.
5-7

Adding PCI Cards

1. 32-bit PCI slots:
The 6021i system board has five 32-bit, 33 MHz 5V PCI slots that require
low profile PCI cards to fit inside the Supermicro SC822 chassis - see
figures 5-6a and 5-6b.
2. 32-bit PCI card installation:
Before installing a PCI add-on card, make sure you choose the correct low
profile card for the type of PCI card you are installing (see step 1, above).
Begin by removing the I/O shield for the PCI slot. Insert the PCI card into
the PCI slot on the motherboard, pushing down with your thumbs evenly on
both sides of the card. Finish by using a screw to secure the top of the card
shield to the chassis. The I/O shield protects the motherboard and its
components from EMI (electromagnetic interference) and aids in proper
ventilation, so make sure there is always a shield covering each slot.
Side View of DIMM Installation into Slot
Notch
Release
Note: Notch
Tab
should align
with the
receptive point
on the slot
Top View of DIMM Installation into Slot
Top View of DIMM Slot
Chapter 5: Advanced Motherboard Setup
DIMM
To Remove:
5-9
Notch
Release
Tab
Release Tab