Table of Contents
Advertisement
SUPERSTORAGESYSTEM SSG-2028R-DN2R40L User's Manual
5-6
Adding PCI Expansion Cards
The SSG-2028R-DN2R40L includes two preinstalled riser cards (RSC-X-68-C)
designed specifically for use in the SC227STS-R2K05P 2U rackmount chassis.
These riser cards support the following PCI Express cards to fit inside the chassis
for each node:
•
One (1) PCI-Express 3.0 x16 low-profile slot
•
One (1) PCI-Express 3.0 x8 low-profile slot
Installing an Expansion Card
1. After powering down the system, remove the PCI slot shield.
2. Fully seat the card into the slot, pushing down with your thumbs evenly on
both sides of the card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shield protects the motherboard and its components from EMI
and aid in proper ventilation, so make sure it is always in place.
5-12
5-7
Motherboard Details
Figure 5-2. X10DSN-TS Motherboard Layout
(not drawn to scale)
SXB1
LAN1
LAN2
LAN CTRL
CPU2_PORT1B
CPU2_PORT1A
FAN2
CPU2_PORT2D
Battery
CPU2_PORT2C
BMC
CPU2_PORT2B
BIOS
CPU2_PORT2A
LICENSE
JSLOT1
SAN MAC
CPU2
1
GU2
PM1 PM2
AM3
AM1
AM2
Notes:
1. For the latest CPU/Memory updates, please refer to our website at
www.supermicro.com/products/motherboard/ for
2. Use only the correct type of onboard CMOS battery as specified by the
manufacturer. Do not install the onboard battery upside down to avoid
possible explosion.
3. Jumpers not indicated are for test purposes only.
4. All graphics shown in this manual were based upon the latest PCB Revision
available at the time of publishing of the manual. The motherboard you've
received may or may not look exactly the same as the graphics shown in this
manual.
Chapter 5: Advanced Motherboard Setup
USB0/1(3.0)
(Reserved)
VGA
JSIOM
JBT1
X10DSN-TS
PCH
Rev. 1.00
MAC CODE
IPMI CODE
BAR CODE
CPU1
1
GU1
AM5
AM4
http://
details.
5-13
JTPM1
Advertisement
Table of Contents
