Table of Contents
Advertisement
About This Manual
This manual is written for professional system integrators and PC technicians.
It provides information for the installation and use of the SuperServer 6021i.
Installation and maintainance should be performed by experienced technicians
only.
The SuperServer 6021i is a high-end dual processor 2U rackmount server based
on the SC822 2U rackmount server chassis and the P3TDDE, a dual processor
motherboard that supports single or dual Intel Pentium
1.40 GHz processors and single or dual low power Pentium
front bus speeds of 133 and 100 MHz and up to 4 GB SDRAM main memory.
CPU watchdog capability is also supported.
Manual Organization
Chapter 1: Introduction
The first chapter provides a checklist of the main components included with the
server system and describes the main features of the SUPER P3TDDE mainboard
and the SC822 chassis, which make up the SuperServer 6021i.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the SuperServer 6021i
into a rack and check out the server configuration prior to powering up the
system.
If your server was ordered without processor and memory com-
ponents, this chapter will refer you to the appropriate sections of the
manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions
and information provided by the control panel on the chassis as well as
other LEDs located throughout the system.
Preface
iii
Preface
®
III FCPGA 500 MHz -
®
III processors at
Advertisement
Table of Contents
