Table of Contents
Advertisement
S
UPERSERVER 6021i User's Manual
Onboard IDE RAID
J17 gives you the option of dis-
abling/enabling the onboard IDE
RAID.
See Table 5-23 for pin defi-
nitions.
5-10 Parallel Port, ACP, AGP and Floppy/Hard Disk Drive
Connections
Note the following when connecting the floppy and hard disk drive cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors
to provide for two floppy disk drives.
always connects to drive A, and the connector that does not have
twisted wires always connects to drive B.
• The 80-wire ATA66/100 IDE hard disk drive cable that came with your
system has two connectors to support two drives.
should be used to take advantage of the speed this new technology
offers. The blue connector connects to the onboard IDE connector inter-
face and the other connector(s) to your hard drive(s). Consult the docu-
mentation that came with your disk drive for details on actual jumper
locations and settings for the hard disk drive.
O nboard IDE RAID
Jumper
Position
1-2
2-3
Position
1-2
The connector with twisted wires
5-20
T able 5-23
Enable/D isable
Definition
Enabled
Disabled
(J17)
Position
2-3
This special cable
Advertisement
Table of Contents
