Supermicro SUPERSERVER 6021i User Manual page 81

IR Transmission Delay
If "Enabled", the transmssion of IR (infrared) signals will be delayed. The settings
are "Enabled" and "Disabled".
UR2 Duplex Mode
This option sets the UR2 Duplex Mode. The settings are "Full" and "Half".
Use IR Pins
This item is used to change the Use IR Pins setting. The settings are "RxD2,
TxD2" and "IR-Rx2Tx2".
Onboard Parallel Port
This option allows the user to set the address and the corresponding IRQ
for the onboard parallel port. The settings are "Disabled", "378/IRQ7", "278/
IRQ5" and "3BC/IRQ7".
Parallel Port Mode
This option sets the mode for the onboard parallel port. The settings are
"SPP", "EPP", "ECP" and "ECP+EPP".
EPP Mode Select
This option allows the user to select the EPP mode. The settings are "EPP
1.9" and "EPP 1.7".
ECP Mode Use DMA
This option allows the user to select the ECP use DMA mode. The settings
are "1" and "3".
Watch Dog Feature
This option allows the user to enable or disable the Watch Dog Feature. The
settings are "Enabled" and "Disabled".
7-13
Chapter 7: BIOS