Table of Contents
Advertisement
5-6
Adding PCI Cards
PCI Expansion Slots
The X9DRW-iTPF has one Universal PCI slot. Riser cards installed to the system
allow you to add PCI expansion cards (see below). The SC119TQ-R700WB chassis
can support the use of two standard size (full-height, half-length) expansion cards
and one low-profile (4.1" length) expansion card (with pre-installed riser cards).
PCI Card Installation
Before installing a PCI add-on card, make sure you power off the system first. Begin
by removing the top chassis cover. Two riser cards should be pre-installed into the
system. Remove the screws that secure the riser cards to the rear of the chassis
then lift the riser card assembly from the chassis. Insert the PCI card into the riser
card slot, pushing down with your thumbs evenly on both sides of the card - note
that the add-on card attaches to the riser card with a single screw. After the card
has been installed, reinsert the riser card back into the expansion slot on the board,
then secure it with the same screws you removed previously. Finish by replacing
the chassis cover.
Riser Card
RSC-R1UW-2E16 (left side)
RSC-R1UW-E8R (right side)
#
Expansion Card
1
Low-profile (2.536"), 4.1" length
2
Full-height (4.2"), 10" length
Chapter 5: Advanced Serverboard Setup
PCI Slot/Card Configurations
Expansion Card Supported
1x PCI-E x16 and 1x PCI-E x8 cards (full-height, half-length)
1x low-profile PCI-E x8 card (4.1" length)
PCI Card Locations
#
Expansion Card
3
Full-height (4.2"), 6.6" length
5-13
1
2
3
Advertisement
Table of Contents
