Adjustment Of Optical Axis - FujiFilm FUJINON XK6x20 SAF Operation Manual

(2) ADJUSTMENT OF OPTICAL AXIS

The alignment of the optical axes between the camera and the lens can be done as follows.
■ Confirmation of Optical Axis
a. Set the zoom at the telephoto end. Aim the camera so that an object is located at the center of the viewfinder.
b.
Operate the zoom to the wide end. If the object at the center in the vierfinder does not move, the optical axis is
optimum. If not, the optical axis is not optimum. In this case, perform "Adjustment" below.
REAR VIEW
A
a. Slightly loosen eight screws ⑤ .
b. Install the lens onto the camera.
c. Set the zoom at the telephoto end.
d. Aim the camera so that an object is located at the center of the viewfinder.
e. Operate the zoom to the wide end.
f. Confirm that the object is maintained at the center. If not, adjust four adjustment screws ④ using a hexagon
screwdriver (size: 0.89 mm), so that the object is located at the center.
g. Operate the zoom to the telephoto end, and confirm that the object is maintained at the center.
(If the object is not at the center, perform steps 'c' to 'e' again.)
h. After the adjustment is completed, detach the lens from the camera, and then tighten eight screws ⑤ .
i. Finally, confirm that four screws ④ for adjustment of optical axis are securely tightened.
⑤
A
- E20 -
SECTION A - A
④ ③