Operation By Zoom Seesaw Control Lever - FujiFilm FUJINON XK6x20 SAF Operation Manual

(2) Operation by Zoom Seesaw Control Lever

a. Set the zoom servo/manual select knob to "S."
b.
Press the zoom seesaw control lever.
Press T-side of the lever to zoom to the tele side, and the W-side to zoom to the wide side.
For the speed control, adjust the strength to press the lever.
Pressing the lever deeply makes the zoom speed faster, and shallowly makes slower.
<Control of Zoom Maximum Speed>
By means of the zoom maximum speed control knob (see the illustration below), the zoom maximum speed can
be changed in seven steps. Rotate the knob clockwise to increase the speed.
(3) QuickZoom Operation
In quickzoom operation, pressing a switch moves the zoom to the tele end quickly. The operator can use
this function in such occasions listed below.
・ When rapid zooming to the tele end is required to focus on the object precisely.
・ To confirm, in a moment, the composition of the image in the extreme closeup shot.
Operation
a. Set the zoom servo/manual select knob to "S."
b. Keep pressing the quickzoom & auto cruising zoom switch until the zoom reaches the tele end.
c. While pressing the quickzoom & auto cruising zoom switch, perform precise focusing or confirm the
composition of the image in the extreme closeup shot.
d. Release the quickzoom & auto cruising zoom switch.
－ The zoom will move to its former position quickly.
(If you press the quickzoom & auto cruising zoom switch again before the zoom returns to its former
position, the quickzoom movement restarts. After this operation, if the switch is released, the zoom will
move to its former position quickly. )
Note 1. By setting an appropriate switch in the area of "Function & Mode Select Switches" (see page E13),
the return switch and the VTR switch can be used also as a quickzoom & auto cruising zoom switch.
Note 2. In quickzoom operation, the zoom moves at the maximum speed irrespective of the setting position of
the zoom maximum speed control knob.
Note 3.
If you press the quickzoom & auto cruising zoom switch while pressing the zoom seesaw control lever,
the zoom moves in auto cruising zoom operation, not in quickzoom operation.
QUICKZOOM & AUTO CRUISING ZOOM SWITCH
ZOOM MAXIMUM SPEED CONTROL KNOB
- E9 -