■ Mounting
Ⅰ Preparation (1)
Remove the four screws from the storage holes of the drive unit.
①
②
Rotate the black gears for focus, zoom, and iris, so that the protrusion on each white marked gear is aligned
with the corresponding white mark next to the gear.
Ⅱ Preparation (2)
Rotate the focus to infinity, the zoom to telephoto, and
the iris to wide open.
Ⅲ Attaching the drive unit
Make sure the drive unit is not connected to power.
①
Remove the cap covering the drive unit connector on the lens barrel.
Align the mating connectors on the lens barrel and drive unit, insert the positioning pin of the drive unit into
②
the positioning hole in the lens barrel, connect the two units to each other.
③
Keeping both units together, rotate the zoom, focus, and iris rings by two markings on each scale so that
the drive unit gears and the lens barrel gears engage properly.
ZOOM
IRIS
FOCUS
ZOOM
IRIS
- E18 -
FOCUS