FujiFilm FUJINON XK6x20 SAF Operation Manual page 50

⑤
The illustration shows the positions set at the factory.
①
CAMERA COMMUNICATION ON/OFF SWITCH
②
LDS, /i SELECT SWITCH
③
ANALOG ZOOM DEMAND ZOOM MODE FUNCTION ON/OFF SWITCH
④
AUXILIARY SWITCH
⑤ ZOOM MODE SELECT SWITCH
① Camera Communication ON/OFF Switch
This switch changes the function of serial communication with a camera to ON and OFF.
Note.
Set this switch to OFF when a malfunction occurs and it is assumed that the malfunction is caused by a
serial communication failure.
② LDS, /i Select Switch
The choice of metadata interface with the camera can be selected from "ARRI LDS" or "Cooke /i" by setting
this dip switch.
・ON : ARRI LDS
・OFF : Cooke /i
Analog Zoom Demand Zoom Mode Function ON/OFF Switch
③
In a zoom operation with an analog zoom demand control unit, the zoom mode function (function of selecting the
characteristics of "zoom speed vs zoom control signal") can be switched to ON and OFF.
④ Auxiliary Switch
An auxiliary switch.
⑤
Zoom Mode Select Switch
The characteristics of "Zoom Speed
vs Rotational Angle of Zoom Seesaw
Control Lever" can be selected from
ten modes. Refer to the following
figure.
FUNCTION & MODE SELECT SWITCHES
①
②
③
④
W
ROTATIONAL ANGLE OF ZOOM SEESAW CONTROL LEVER
MAX.
- E14 -
No.9
No.4(Normal)
No.0
0
T