■ Mounting
Ⅳ Secure the drive unit
Keeping both units together on a stable surface, screw in the four screws to secure the drive unit to the lens barrel.
Note: DO NOT use any screws other than the original
accessory screws.
DO NOT apply excessive force. A maximum torque of
80Ncm must not be exceeded.
Ⅳ Initialization
Initialize the drive unit and the lens.
①
Set the zoom and focus servo/manual select knobs to "S."
②
While holding down the "VTR" and "RET" switches simultaneously, turn on power to the lens.
After the zoom ring starts to move, release the switches. The LED on the front of the drive unit will
light and the zoom, focus, and iris rings will rotate to initialize the lens. After the initializing
program finishes, the LED will turn off.
③
Turn off power once, and turn on power again.
- E19 -
LED
REMOVE CAP