Power Requirements; Operating Rate; Operating Conditions; Tape - 3M -Matic a20 Instructions And Parts List

4-SPECIFICATIONS

4.1 Power Requirements:

Electrical: 120 Volt, 60Hz, 1Ph
The machine is equipped with a 2.4m [8 foot] standard neoprene covered power cord and a grounded plug.
Contact your 3M Representative for power requirements not listed.

4.2 Operating Rate:

Up to 30 cases per minute, depending on box length. Box drive belt speed is approximately 0.38m/s
[75 feet per minute].

4.3 Operating Conditions:

IMPORTANT SAFEGUARD
Use in dry, relatively clean environments at 4.4
Note: Machine should not be washed down or subjected to conditions causing moisture
condensation on components.
IMPORTANT SAFEGUARD

4.4 Tape:

Scotch
pressure-sensitive fi lm box sealing tapes.
®

4.5 Tape Width:

36mm [1 1/2 inches] minimum to 48mm [2 inches] maximum
a20-NA
Actual production rate is dependent on operator's dexterity.
Boxes must be 18 inches (455mm apart minimum).
WARNING
•
To reduce the risk associated with fire
and explosion hazards:
−
Do not operate this equipment in
potentially fl ammable or explosive
environments.
C to 48.9 C [40 F to 120
o o o
(Specifi cations continued on next page)
12
F] with clean, dry boxes.
o
2011 April